11060-3703 Reed Valve Gasket for Kawasaki SX 300 1987-1991

Reed Valve Gasket for Kawasaki

This reed valve gasket for Kawasaki seals the reed valve assembly on TS 650 watercraft, and it is a direct fit for the OEM part 11060-3703.

Overview

This reed valve gasket for Kawasaki is a sealing component that mounts between the reed valve and the engine intake on TS 650 models. A sound gasket keeps air from leaking past the reed block, which helps the engine hold steady fuel mixture and dependable power. It is intended for owners servicing or rebuilding their 650 engine.

Built For Performance

• Cut to match the OEM reed valve mounting footprint
• Made from material that resists fuel and oil contact
• Helps maintain correct crankcase sealing for consistent running
• Direct replacement for the reed valve gasket on 650 series engines
• Supplied as one gasket for a simple install

Fits These Machines

• for Kawasaki TS 650 1991-1996

On-The-Job Use

• Top end rebuilds where the reed valve must be resealed
• Intake leak repairs on older TS 650 watercraft
• Routine gasket replacement during engine maintenance
• Getting a stored or non-running TS back on the water

Specs At A Glance

Good To Know

Q: Does this gasket fit other 650 engines? A: It is listed for the TS 650 model years shown, and fit can depend on serial number, so confirm compatibility before ordering.

Q: Should I replace the reed valve gasket every time I remove the reed block? A: Yes, a fresh gasket is recommended each time the reed valve is removed to prevent air leaks.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.