11060-3717 Reed Valve Gasket for Kawasaki STX 750 1998

Reed Valve Gasket for Kawasaki

This reed valve gasket for Kawasaki replaces OEM part 11060-3717, sealing the reed valve assembly against the intake to prevent air leaks on the STX 750.

Overview

This reed valve gasket serves as the sealing layer between the reed cage and the intake tract on the Kawasaki STX 750. A fresh reed valve gasket keeps the intake sealed so the engine draws the fuel and air mix it needs without leaning out. This reed valve gasket fits 1998 STX 750 watercraft.

Built For Performance

• Direct replacement for OEM part number 11060-3717
• Precision cut to match the reed cage intake footprint
• Seals the intake tract against air leaks that cause lean running
• Resists fuel, oil, and water exposure found in marine use
• Built to hold its shape under heat and vibration

Fits These Machines

• for Kawasaki STX 750 (1998)

On-The-Job Use

• Replacing a worn or torn gasket during top end service
• Resealing the intake after pulling the reed valve assembly
• Routine maintenance on the STX 750 engine

Specs At A Glance

Good To Know

Q: What does this gasket actually seal? A: It seals the reed valve assembly to the intake, stopping air leaks that would otherwise make the engine run lean.

Q: Should the gasket be replaced any time the reed valve is removed? A: Yes, a new gasket is recommended whenever the reed valve is pulled so the surfaces seal cleanly on reassembly.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.