11060-3717 Reed Valve Gasket for Kawasaki SXi 750 1995-1996

Reed Valve Gasket for Kawasaki

The Reed Valve Gasket for Kawasaki replaces OEM 11060-3717, sealing the reed valve assembly against the intake to keep the crankcase airtight on SXi 750 models.

Overview

This Reed Valve Gasket for Kawasaki is a direct-fit sealing component for the reed cage on the SXi 750. It seals the reed valve block to the crankcase to keep the intake sealed and prevent air leaks. Built for riders maintaining or rebuilding the top end of their Kawasaki personal watercraft engine.

Built For Performance

• Direct replacement for OEM part number 11060-3717
• Precision-cut to match the reed valve block footprint
• Seals the intake tract against air leaks that rob power
• Resistant to fuel, oil, and two-stroke mix exposure
• Works with stock reed cage and intake hardware
• Simple bolt-on install with no modification required

Fits These Machines

• for Kawasaki SXi 750 1995
• for Kawasaki SXi 750 1996

On-The-Job Use

• Top-end rebuilds and reed valve service
• Intake leak repairs on two-stroke jet ski engines
• Routine gasket replacement during engine tear-down
• Restoring a rough-running SXi 750 back to smooth idle

Specs At A Glance

Good To Know

Q: Does this gasket come as a single piece? A: Yes, this is one reed valve gasket cut to fit the SXi 750 reed block and matches OEM 11060-3717. It installs between the reed cage and crankcase.

Q: Should I replace this gasket every time I remove the reed valve? A: Yes, a fresh gasket each time the reed valve is removed prevents air leaks that can lean out the mixture. Reusing an old gasket risks sealing issues.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.