1193204 Backhoe Bucket Shanks & 1U3202 Bucket Teeth with Pins Retainers for J200

Backhoe Bucket Shanks and Bucket Teeth for J200

This set pairs backhoe bucket shanks with bucket teeth and pins with retainers, referencing part numbers 1193204 and 1U3202, to rebuild worn digging edges on the listed J200 application.

Overview

These backhoe bucket shanks and bucket teeth rebuild the digging edge so the bucket bites cleanly again. The set includes pins and retainers for securing the teeth to the shanks. It suits operators repairing worn ground-engaging hardware on the J200 machine.

Built For Performance

• Bucket teeth shaped for penetrating compacted soil and gravel
• Shanks weld to the bucket lip to carry the tooth load
• Pins and retainers hold teeth in place during digging
• Part numbers 1193204 and 1U3202 for reference against existing hardware
• Replaceable tooth design lets worn tips be swapped without rebuilding the lip

Fits These Machines

• for J200

On-The-Job Use

• Rebuilding a worn backhoe bucket edge
• Trenching and digging in compacted ground
• Restoring digging performance after tooth wear
• Routine replacement of ground-engaging hardware

Specs At A Glance

Good To Know

Q: How do I know these teeth and shanks match my bucket? A: Compare the part numbers 1193204 and 1U3202 against your current shanks and teeth. Check the shank dimensions and pin style before ordering.

Q: Are the retainers reusable after a tooth swap? A: Pins and retainers are typically replaced along with the teeth to keep the fit tight. Inspect used hardware and swap any bent or worn pieces.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.