12 Tooth Front Steel Sprocket for Honda ATC200X fits 1986-1987 All Terrain Cycle

12 Tooth Front Steel Sprocket for for Honda

The 12 tooth front steel sprocket is a replacement drive gear that transmits engine torque to the drivetrain of for Honda ATC200X All Terrain Cycles.

Overview

This 12 tooth front steel sprocket is built for long-term service and consistent engagement under varied riding conditions. The 12 tooth front steel sprocket serves as a direct replacement for worn factory parts. Riders rely on this 12 tooth front steel sprocket to maintain smooth acceleration and drivetrain integrity.

Built For Performance

• Heavy-duty steel alloy composition
• Accurate tooth spacing for reduced vibration
• Heat-treated surfaces to resist pitting
• Standard splines for a secure output shaft fit
• Protective coating against moisture

Fits These Machines

• for Honda ATC200X 1986
• for Honda ATC200X 1987

On-The-Job Use

• Restoring drivetrain efficiency for vintage cycles
• Replacing rusted or damaged drive sprockets
• General drivetrain maintenance and inspection

Specs At A Glance

Good To Know

Q: Does this sprocket include a locking washer? A: This listing is for the sprocket only, so be prepared to reuse or replace your existing mounting hardware. A: Check the condition of the retaining clip before finalizing the installation.

Q: How often should front sprockets be inspected? A: Inspect the sprocket for hooking or thinning teeth every time the chain is adjusted or cleaned. A: Early detection of wear saves the rest of your drivetrain components.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.