1253327 Carburetor Mounting Flange for Polaris Switchback 800 2004-2005

Carburetor Mounting Flange for Polaris

This carburetor mounting flange secures the carb to the engine intake on Polaris Switchback 800 machines, cross-referencing OEM part 1253327.

Overview

This carburetor mounting flange is a direct-fit intake component that seals and supports the carburetor on Polaris Switchback 800 snowmobiles. It keeps the carburetor mounting flange firmly seated against the engine intake to prevent air leaks that rob performance.

Built For Performance

• Precision-formed flange face for a tight seal at the intake
• Constructed to resist heat and vibration in the engine bay
• Bolt pattern matched to the OEM 1253327 mounting points
• Seals against unmetered air that causes lean running
• Replaces a cracked or warped factory flange

Fits These Machines

• for Polaris Switchback 800, 2004-2005

On-The-Job Use

• Carburetor rebuilds and intake resealing
• Restoring sleds that idle rough from air leaks
• Routine maintenance on trail machines

Specs At A Glance

Good To Know

Q: Will this fit my 2004 Switchback 800? A: This flange is listed for the Polaris Switchback 800 in 2004 and 2005 and cross-references 1253327, so verify your model year before ordering.

Q: Do I need a gasket with this flange? A: A gasket is recommended at the mounting surface to complete the seal. Check your existing hardware and intake condition during installation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.