1253423 Carb Mounting Flange for Polaris Edge Touring 600 2005-2006

Carb Mounting Flange for Polaris

This carb mounting flange, part number 1253423, secures the carburetor to the engine intake on Polaris Edge Touring 600 snowmobiles from 2005 to 2006, sealing the connection to prevent air leaks.

Overview

This carb mounting flange is a direct-fit intake component for the Polaris Edge Touring 600, holding the carburetor firmly against the engine while sealing the joint against vacuum leaks. A cracked or hardened flange can cause lean running and poor throttle response, so replacing it restores a clean, consistent air-fuel mixture. It is built for riders maintaining or rebuilding the intake system on their 2005 to 2006 Edge Touring 600.

Built For Performance

• Direct-fit replacement for Polaris part number 1253423
• Rigid mounting surface keeps the carburetor aligned with the intake port
• Seals the carburetor-to-engine joint against vacuum leaks
• Resists fuel vapor, oil, and heat exposure in the engine bay
• Simple bolt-on installation with no modification required

Fits These Machines

• for Polaris Edge Touring 600, 2005
• for Polaris Edge Touring 600, 2006

On-The-Job Use

• Carburetor rebuilds and intake reseals
• Seasonal maintenance on older Edge Touring 600 sleds
• Replacing a cracked or warped original flange
• Restoring smooth idle and throttle response

Specs At A Glance

Good To Know

Q: How do I know if my carb mounting flange needs replacing? A: Look for cracks, hardening, or a fuel-stained surface around the flange, and check for a hunting idle or lean condition that points to a vacuum leak.

Q: Does this flange require a gasket? A: A gasket is typically used at the mounting surface, so inspect your existing one and replace it if it is compressed or damaged during installation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.