13 Tooth Front Drive Sprocket for Honda CR250R CR 250R 1988-2007

13 Tooth Front Drive Sprocket for Honda CR250R

This 13 tooth front drive sprocket is a replacement countershaft sprocket that transfers engine power to the drive chain on for Honda CR250R dirt bikes from 1988 through 2007.

Overview

This 13 tooth front drive sprocket fits for Honda CR250R models built between 1988 and 2007, delivering power from the transmission to the rear wheel through the chain. The 13 tooth count is a common choice for riders tuning gearing and acceleration on the CR 250R. It is a straightforward replacement sprocket for maintenance or gearing changes.

Built For Performance

• 13 tooth countershaft sprocket sized for the for Honda CR250R
• Designed to mesh cleanly with standard 520 pitch chain
• Steel construction built to handle motocross and trail loads
• Mounts to the countershaft output for direct chain drive
• Fits model years 1988 through 2007

Fits These Machines

• for Honda CR250R, 1988
• for Honda CR250R, 1990
• for Honda CR250R, 1995
• for Honda CR250R, 2000
• for Honda CR250R, 2007

On-The-Job Use

• Replacing a worn front sprocket on the for Honda CR250R
• Changing gearing for quicker acceleration on the track
• Routine drivetrain maintenance on the CR 250R
• Setting up a race bike for tighter circuits

Specs At A Glance

Good To Know

Q: Is this an original Honda sprocket? A: No, this is an aftermarket 13 tooth front drive sprocket made to fit for Honda CR250R models; it is not an original Honda part.

Q: Which chain pitch does this sprocket use? A: This front drive sprocket is intended for the standard 520 pitch chain used on the for Honda CR250R, but confirm your chain and sprocket specs before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.