13033-1010 Wrist Pin Bearing for Kawasaki TS 650 1989-1996

Wrist Pin Bearing for Kawasaki

This wrist pin bearing is a small engine component that lets the piston pin rotate smoothly inside the connecting rod on select Kawasaki personal watercraft, and it carries the OEM cross-reference 13033-1010.

Overview

This wrist pin bearing is a small engine component that sits between the piston pin and the connecting rod small end, allowing smooth rotation under load. It fits select Kawasaki personal watercraft powered by the 650 two-stroke engine, including the TS 650. Choose it when rebuilding a top end and replacing worn or loose pin bearings.

Built For Performance

• Needle-roller design handles the rocking motion at the small end
• Original equipment cross-reference 13033-1010 for easy lookup
• Hardened bearing surfaces for high-cycle two-stroke duty
• Direct-fit replacement for a worn or noisy wrist pin bearing
• Compact size suited to small-bore piston and rod assemblies

Fits These Machines

• for Kawasaki TS 650
• for Kawasaki 650 two-stroke models 1989 through 1996

On-The-Job Use

• Top-end rebuilds and piston replacement
• Crank and connecting rod service
• Marine engine maintenance on personal watercraft
• Routine refresh on high-hour 650 engines

Specs At A Glance

Good To Know

Q: How often should a wrist pin bearing be replaced? A: Most builders fit a new bearing whenever the piston or rod comes apart, since the part is inexpensive relative to the labor involved.

Q: Does this bearing require special tools to install? A: It typically slides into place on assembly, but you should check pin and rod bore condition before fitting it.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.