13101-3708 Starter Drive for Kawasaki SX 650 1987-1993 Jet Ski

Starter Drive for Kawasaki SX 650

This starter drive with OEM cross-reference 13101-3708 is the one-way clutch assembly that engages the starter motor to crank the engine on the Kawasaki SX 650 personal watercraft.

Overview

This starter drive for Kawasaki is the internal clutch mechanism that transfers turning force from the starter motor to the engine flywheel so the engine spins up and fires. It serves riders maintaining or rebuilding a 1987 to 1993 Kawasaki SX 650 that has begun to slip, grind, or fail to crank. The 13101-3708 starter drive for Kawasaki restores reliable starting without replacing the entire starter system.

Built For Performance

• One-way clutch design engages the starter and releases once the engine starts
• Cross-references OEM part number 13101-3708
• Steel roller and spring construction built to handle repeated cranking loads
• Sealed assembly resists water intrusion common in personal watercraft use
• Drop-in replacement for the original starter drive on covered SX 650 models
• Balanced rotating mass to reduce vibration during engagement

Fits These Machines

• for Kawasaki SX 650 1987
• for Kawasaki SX 650 1988
• for Kawasaki SX 650 1989
• for Kawasaki SX 650 1990
• for Kawasaki SX 650 1991
• for Kawasaki SX 650 1992
• for Kawasaki SX 650 1993

On-The-Job Use

• Restoring a Kawasaki SX 650 that turns over slowly or not at all
• Routine starter system service during engine rebuilds
• Repairing a slipping or grinding starter on older PWC units
• Seasonal maintenance for riders keeping a 1980s or 1990s machine on the water
• Replacing a worn drive before failure strands the craft at the launch

Specs At A Glance

Good To Know

Q: Will this fit my 1987 Kawasaki SX 650? A: It is listed for the 1987 through 1993 SX 650, but serial number and production changes can affect fit, so verify your model year and engine before ordering.

Q: Do I need to replace anything else with the starter drive? A: Inspect the starter motor, bendix gear, and flywheel teeth while the drive is out, since worn mating parts can shorten the life of the new unit.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.