13101-3708 Starter Drive for Kawasaki SX-R 800 2003-2011 Jet Ski

Starter Drive for Kawasaki

This starter drive is a replacement starter motor assembly for Kawasaki personal watercraft, delivering the cranking power needed to turn over the engine and get you on the water; it references OEM part number 13101-3708.

Overview

This starter drive is a direct-fit replacement starter motor for Kawasaki SX-R 800 personal watercraft, built to spin the engine reliably at every start. As a starter drive for Kawasaki, it serves riders who need a dependable cranking component without paying original equipment pricing. The 13101-3708 reference lets you confirm the match against your existing unit before installation.

Built For Performance

• Direct replacement for OEM part number 13101-3708
• Sealed motor housing built to resist water and spray intrusion
• High-torque gearing sized to crank the 800cc two-stroke engine
• Mounting flange and bolt pattern matched to the factory starter location
• Pre-assembled unit ready to bolt in with the original hardware

Fits These Machines

• for Kawasaki SX-R 800, 2003
• for Kawasaki SX-R 800, 2004
• for Kawasaki SX-R 800, 2005
• for Kawasaki SX-R 800, 2006
• for Kawasaki SX-R 800, 2007
• for Kawasaki SX-R 800, 2008
• for Kawasaki SX-R 800, 2009
• for Kawasaki SX-R 800, 2010
• for Kawasaki SX-R 800, 2011

On-The-Job Use

• Replacing a starter that clicks, drags, or fails to spin the engine
• Routine freshening of the starting system on a seasonally used ski
• Getting back on the water fast after a starter failure mid-season
• Servicing stand-up style personal watercraft with an OEM-matched unit

Specs At A Glance

Good To Know

Q: Will this starter drive fit my SX-R 800 directly? A: It is built as a replacement for OEM part number 13101-3708, so confirm the number on your original starter or in your service manual before ordering. Fit can also vary by serial number and production run.

Q: Do I need to change anything else when replacing the starter? A: Inspect the starter relay, battery cables, and battery condition at the same time, since weak electrical connections are a common cause of slow cranking. Clean and tighten all terminals during installation for best results.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.