13280-3756 Bearing Housing for Kawasaki SC 650 1991-1995 PWC Part

Bearing Housing for Kawasaki

This bearing housing, part number 13280-3756, supports and locates the driveshaft bearing on Kawasaki SC 650 personal watercraft for stable, low-vibration operation.

Overview

This bearing housing is a replacement mounting component for the Kawasaki SC 650, holding the bearing that keeps the driveshaft aligned inside the hull. The bearing housing pairs with OEM reference 13280-3756 so riders can restore proper shaft support during driveline service. It suits owners performing routine rebuilds or replacing a worn housing on a 1991-1995 model.

Built For Performance

• Cast housing sized to the OEM 13280-3756 mounting footprint
• Machined bore for accurate bearing seating and shaft alignment
• Corrosion-resistant finish suited to regular water exposure
• Bolt-on installation using existing mounting points
• Reinforced body to resist cracking under driveshaft load
• Direct replacement for the original housing on the SC 650

Fits These Machines

• for Kawasaki SC 650 (1991-1995)

On-The-Job Use

• Driveshaft bearing support on Kawasaki SC 650 watercraft
• Driveline rebuilds and routine bearing replacement
• Restoring alignment after housing wear or damage
• Seasonal maintenance on older personal watercraft

Specs At A Glance

Good To Know

Q: How do I know this bearing housing fits my watercraft? A: Confirm your model is a Kawasaki SC 650 from 1991 through 1995 and that your existing housing carries reference 13280-3756. Checking the part number on your current housing is the safest way to verify.

Q: Is the bearing included with this housing? A: This listing covers the bearing housing only, so inspect and replace the bearing separately if it shows wear. Reusing a worn bearing can cause noise and premature housing damage.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.