13280-3756 Bearing Housing for Kawasaki TS 650 1989-1996

Bearing Housing for Kawasaki

This bearing housing for Kawasaki watercraft supports the driveshaft bearing and seals it against water intrusion, and it cross-references OEM part number 13280-3756.

Overview

This bearing housing for Kawasaki is a replacement driveline component that holds and aligns the shaft bearing inside the pump and driveshaft assembly. It keeps the bearing seated under load and helps hold grease in while keeping water out, so the shaft spins true. It is aimed at riders and mechanics refreshing the driveline on a Kawasaki TS 650 personal watercraft.

Built For Performance

• Cross-references OEM part number 13280-3756 for straightforward matching
• Houses and centers the driveshaft bearing to keep shaft alignment true
• Seals the bearing cavity against water and debris intrusion
• Retains grease around the bearing for continued lubrication
• Direct-fit replacement for the original housing position
• Built to withstand continuous marine use in wet conditions

Fits These Machines

• for Kawasaki TS 650, 1989
• for Kawasaki TS 650, 1990
• for Kawasaki TS 650, 1991
• for Kawasaki TS 650, 1992
• for Kawasaki TS 650, 1993
• for Kawasaki TS 650, 1994
• for Kawasaki TS 650, 1995
• for Kawasaki TS 650, 1996

On-The-Job Use

• Driveline rebuilds on the TS 650 hull
• Replacing a worn or corroded bearing housing during pump service
• Routine driveline inspection and bearing repacking
• Restoring proper shaft alignment after driveline repair

Specs At A Glance

Good To Know

Q: Is this an original Kawasaki part? A: No, it is an aftermarket bearing housing that cross-references OEM number 13280-3756. It is not manufactured or sold by Kawasaki.

Q: What should I check before installing it? A: Inspect the driveshaft bearing and seals for wear while the housing is off, since a bad bearing can damage a new housing. Confirm your craft's model year and serial number match the listed fitment before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.