144mm ID Jet Pump Wear Ring for Yamaha Wave Venture 700 1995-1996

Jet Pump Wear Ring for Yamaha

This 144mm inside diameter jet pump wear ring is a replacement component that fits into the pump housing to maintain a close clearance with the impeller, protecting pump efficiency.

Overview

This jet pump wear ring is built for Yamaha Wave Venture 700 personal watercraft and is designed to keep the proper clearance between the impeller and housing wall. The jet pump wear ring helps restore lost thrust and reduce cavitation as the original ring wears down over time. It is a practical service part for owners maintaining older pumps.

Built For Performance

• 144mm inside diameter matched to the listed pump application
• Maintains a close impeller-to-housing clearance to support thrust
• Helps reduce cavitation caused by worn ring surfaces
• Rugged construction resists erosion from water and debris flow
• Direct-fit replacement for the pump housing for straightforward service

Fits These Machines

• for Yamaha Wave Venture 700, 1995-1996

On-The-Job Use

• Restoring pump efficiency on worn personal watercraft
• Routine jet pump rebuilds and impeller service
• Reducing cavitation and slipping under acceleration
• Seasonal maintenance on older Yamaha pump assemblies

Specs At A Glance

Good To Know

Q: What does a jet pump wear ring do? A: It lines the pump housing and controls the clearance around the impeller so water is pushed efficiently. A worn ring increases clearance and can cause cavitation and lost thrust.

Q: How do I check if this ring fits my pump? A: It is listed for Yamaha Wave Venture 700 models from 1995 to 1996 with a 144mm inside diameter. Confirm your model, year, and pump dimensions before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.