1503 Carbon Ring Kit for Sea-Doo GTI STD 2006

Carbon Ring Kit for Sea-Doo GTI STD 1503

This carbon ring kit is a driveline sealing component for Sea-Doo GTI STD 1503 personal watercraft, designed to seal the driveshaft where it meets the hull and keep water out of the engine compartment.

Overview

This carbon ring kit is a replacement sealing assembly for the driveshaft passage on Sea-Doo GTI STD 1503 watercraft. The carbon ring kit seats against the floating seal to keep cooling water and lake spray out of the hull while the shaft spins. It is intended for riders performing routine driveline maintenance or replacing a worn or scored seal on their 1503-powered machine.

Built For Performance

• Carbon sealing ring material resists wear from continuous shaft rotation
• Seals the driveshaft bore against water intrusion into the hull
• Direct-fit replacement for the factory sealing assembly
• Withstands the heat and friction of sustained high-RPM operation
• Kit form allows replacement of the ring and related seal components together
• Compatible with the Sea-Doo 1503 engine platform

Fits These Machines

• for Sea-Doo GTI STD 1503 (2006)

On-The-Job Use

• Routine driveshaft and seal maintenance on 2006 GTI STD models
• Repairing water intrusion at the driveshaft hull penetration
• Seasonal rebuilds of the jet pump driveline
• Servicing after a worn ring causes excess bilge water

Specs At A Glance

Good To Know

Q: Do I need to remove the engine to install this? A: No, the carbon ring kit is normally serviced from the driveshaft area at the rear of the hull, though access varies by model. Follow your service manual procedure for the 2006 GTI STD.

Q: How do I know the carbon ring needs replacing? A: Excess water in the bilge, a visible groove or crack in the ring, or a loose seal are common signs. Inspect the ring at each driveline service interval.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.