1503 Drive Shaft Upgrade Kit for Sea-Doo GTI SE 155 2009-2010

Drive Shaft Upgrade Kit for Sea-Doo GTI SE 155 1503

This drive shaft kit is a replacement driveline component made to transfer engine torque to the jet pump on the 2009-2010 Sea-Doo GTI SE 155 1503 personal watercraft.

Overview

This drive shaft kit is designed to replace a worn, bent, or corroded shaft on the Sea-Doo GTI SE 155 1503. It connects the engine output to the impeller, keeping the jet pump delivering thrust under load. Owners and mechanics servicing a 2009-2010 GTI SE 155 will find this drive shaft kit suited for repair and rebuild work.

Built For Performance

• Made from corrosion-resistant marine-grade steel for extended service in water environments
• Precision-cut splines for secure engagement with the coupler and impeller
• Balanced profile to help minimize vibration at higher RPM
• Hardened bearing surfaces to resist wear over repeated use
• Dimensions matched to the 1503 engine platform for direct fitment

Fits These Machines

• for Sea-Doo GTI SE 155 1503 (2009)
• for Sea-Doo GTI SE 155 1503 (2010)

On-The-Job Use

• Driveline repair on personal watercraft
• Replacing a damaged shaft after impact or prolonged use
• Jet pump and impeller service
• Off-season rebuilds and maintenance

Specs At A Glance

Good To Know

Q: Is this an original Sea-Doo part? A: No, this is an aftermarket drive shaft kit made for Sea-Doo applications and is not produced by Sea-Doo.

Q: Should I check other driveline parts during installation? A: Yes, inspect the coupler, bearings, and seals, since worn components can affect the performance and lifespan of a new drive shaft.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.