1503 Jet Pump Assembly for Sea-Doo Wake Pro HO 2019

Jet Pump Assembly for Sea-Doo

The jet pump assembly for Sea-Doo is a complete propulsion unit that draws water in and forces it out to move the personal watercraft; it is the replacement option for the 2019 Wake Pro HO 1503 model.

Overview

This jet pump assembly for Sea-Doo is built to restore thrust in the 1503-powered Wake Pro HO. As a drop-in replacement for the 2019 model year, this jet pump assembly for Sea-Doo keeps impeller, wear ring, and housing working as a matched set. Ideal for riders replacing a worn or damaged pump on the bench or in the shop.

Built For Performance

• Matched impeller and wear ring for consistent clearance and pressure
• Stainless impeller for salt and freshwater use
• Housing built to OEM mounting points for a direct fit
• Sealed bearings for extended service life
• Balanced rotating assembly to limit vibration at high RPM
• Complete unit that installs without reusing the old housing

Fits These Machines

• for Sea-Doo Wake Pro HO 1503, 2019

On-The-Job Use

• Replacing a pump damaged by rocks, sand, or debris
• Rebuilding a high-hours PWC before the season starts
• Restoring acceleration and top speed after wear ring erosion
• Fleet maintenance for rental or tour operators

Specs At A Glance

Good To Know

Q: Will this pump fit my 2019 Wake Pro HO direct? A: Yes, the mounting pattern and shaft splines are made for the 2019 1503 Wake Pro HO. Confirm your hull serial number before ordering since mid-year changes can occur.

Q: Do I need to replace the wear ring too? A: This pump arrives as a complete assembly, so the wear ring is already fitted. Inspect the intake grate and driveshaft while the pump is off the boat.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.