1929CS Ring Set for Wiseco 49.00mm

Ring Set for Wiseco

This 49.00mm ring set is a piston ring replacement component designed to seal the combustion chamber and control oil along the cylinder wall.

Overview

The Wiseco 1929CS ring set is a 49.00mm piston ring set built to restore compression and oil control in small bore engines. Each ring set is sized at 49.00mm to match the corresponding piston bore. This ring set suits rebuilders and riders replacing worn rings during a top end refresh.

Built For Performance

• 49.00mm bore size for a matched fit to the piston
• Ring set configuration for piston sealing and oil control
• Manufactured to Wiseco ring set specifications
• Direct replacement for the original ring set of the same size

Specs At A Glance

Good To Know

Q: How do I confirm this ring set fits my piston? A: Match the 49.00mm bore size and the 1929CS part number to your piston before ordering. Bore size alone is not always enough, so verify against your piston spec.

Q: Can I install rings without checking end gap? A: Ring end gap should always be measured and adjusted to the engine manufacturer specification before assembly. Skipping this step can cause poor sealing or ring damage.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.