2 PCS Front Disc Brake Pad Wear Sensors LH/RH for BMW E90 325i 328xi 330xi

Brake Pad Wear Sensors for BMW E90

These front disc brake pad wear sensors for BMW E90 models detect pad wear and trigger the dashboard service indicator before pads reach their limit. The set includes left and right sensors for a complete front axle replacement.

Overview

These brake pad wear sensors for BMW E90 cars monitor pad thickness and signal the driver when replacement is due. Sold as a pair, the set covers both the left and right front positions. Each brake pad wear sensor for BMW E90 models installs at the factory location and connects to the existing wear indicator circuit.

Built For Performance

• Two-sensor set covers both front left and front right positions
• Designed to trigger the dashboard wear indicator at the correct threshold
• Sealed connector ends resist moisture and road debris
• Direct-fit replacement for the factory wear sensor locations
• Simple clip-in installation during brake pad service

Fits These Machines

• for BMW E90 325i
• for BMW E90 328xi
• for BMW E90 330xi

On-The-Job Use

• Front brake pad replacement service on E90 platforms
• Restoring a failed or cut wear indicator circuit
• Clearing brake service warnings after new pads are installed
• Routine brake maintenance on daily-driven sedans

Specs At A Glance

Good To Know

Q: Do I need both sensors? A: Most E90 front axles use one sensor per side, so replacing both at once avoids a second warning shortly after service. Confirm your vehicle's sensor count before ordering.

Q: Can these be reused with new pads? A: Wear sensors are typically single-use, and a tripped sensor must be replaced along with the pads. Install the new sensors during the same brake job to keep the indicator working.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.