2×Prop Shaft U-Joint for Polaris RZR Ranger Sportsman General 1000 900 800 Front

Prop Shaft U-Joint for Polaris

This pair of prop shaft U-joints rebuilds the front driveshaft on Polaris RZR, Ranger, Sportsman, and General machines, restoring smooth power transfer to the front differential.

Overview

These prop shaft U-joints are replacement joints for the front driveshaft on Polaris side-by-side and ATV models. Each U-joint takes up the angle changes in the shaft while carrying torque from the transmission to the front differential. Sold as a pair, they suit riders rebuilding a worn or noisy front prop shaft on RZR, Ranger, Sportsman, and General machines.

Built For Performance

• Sold as a set of two U-joints for a complete prop shaft rebuild
• Needle bearing cups for smooth rotation under load
• Hardened trunnion surfaces resist wear from constant angle changes
• Sealed caps hold grease in and keep water and grit out
• Snap ring retention matches the factory shaft setup

Fits These Machines

• for Polaris RZR 1000
• for Polaris RZR 900
• for Polaris RZR 800
• for Polaris Ranger 1000
• for Polaris Ranger 900
• for Polaris Ranger 800
• for Polaris Sportsman 1000
• for Polaris Sportsman 900
• for Polaris Sportsman 800
• for Polaris General 1000

On-The-Job Use

• Trail riding where the front shaft cycles through constant angle changes
• Mud and water crossings that work over joint seals
• Farm and ranch chores with frequent four-wheel-drive engagement
• Rebuilding a clicking or vibrating front prop shaft

Specs At A Glance

Good To Know

Q: What are the signs of a bad prop shaft U-joint? A: A clicking or clunking noise on takeoff, vibration through the floor, or visible play when you twist the shaft by hand all point to worn joints. Replacing both joints at once keeps the shaft balanced.

Q: Are these a direct fit on my Polaris? A: They are built to match the front prop shaft on the listed RZR, Ranger, Sportsman, and General models. Measure your existing joint caps and confirm your model year before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.