Skip to product information
1 of 1

2-Stroke Exhaust Gasket Spring Kit for Ski-Doo MXZ 800 E-Tec 2016-2017

2-Stroke Exhaust Gasket Spring Kit for Ski-Doo MXZ 800 E-Tec 2016-2017

Regular price $184.19
Regular price Sale price $184.19
Sale Sold out
Quantity

Exhaust Gasket and Spring Kit for Ski-Doo MXZ 800

This exhaust gasket and spring kit seals the joint between the exhaust manifold and pipe on 2-stroke E-Tec snowmobiles, keeping exhaust pressure where it belongs.

Overview

This exhaust gasket and spring kit is built for the Ski-Doo MXZ 800 2-Stroke E-Tec and provides the seals and tension springs needed at the exhaust connection point. Riders servicing their sled's exhaust system use this kit to restore a tight seal and eliminate leaks at the flange. It suits anyone replacing worn gaskets or lost springs during routine exhaust maintenance on the 800 E-Tec platform.

Built For Performance

  • Complete kit pairs exhaust gaskets with matching tension springs
  • Gasket material formulated to withstand high exhaust temperatures
  • Springs hold steady tension at the pipe-to-manifold joint
  • Direct replacement for worn or blown-out factory sealing components
  • Designed around the 800 2-stroke E-Tec exhaust layout

Fits These Machines

  • for Ski-Doo MXZ 800 2-Stroke E-Tec, 2016
  • for Ski-Doo MXZ 800 2-Stroke E-Tec, 2017

On-The-Job Use

  • Exhaust flange resealing during top-end or pipe service
  • Trailside repair after a gasket burn-through or lost spring
  • Seasonal pre-ride inspection of the exhaust joint
  • Restoring proper backpressure after exhaust work

Specs At A Glance

Type Exhaust gasket and spring kit
Engine 800 2-stroke E-Tec
Vehicle Fit Ski-Doo MXZ
Model Years 2016-2017

Good To Know

Q: How often should exhaust gaskets and springs be replaced? A: Inspect them whenever the exhaust is apart or at the start of each season, and replace any gasket showing cracking, soot trails, or compression loss, plus any spring that has stretched or lost tension.

Q: Can I install this kit without removing the whole exhaust system? A: On most 800 E-Tec sleds the gasket and springs at the flange can be serviced by loosening the pipe and spring hooks, though consulting your service manual for the exact procedure is recommended.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.

Get it between -

View full details