2 Tie Rod Sets Fit Kawasaki KVF750 Brute Force 750 4X4I 2005-2016 Ball Joint

Tie Rod Sets for Kawasaki

This tie rod set includes two complete tie rod assemblies with ball joints to replace worn steering linkage and restore precise wheel alignment on 2005-2016 Kawasaki KVF750 Brute Force 750 4X4i ATVs.

Overview

The tie rod sets for Kawasaki KVF750 Brute Force ATVs deliver direct bolt-on replacement of both inner and outer tie rod ends, eliminating steering slop and uneven tire wear. Built for riders who push their machines through mud, rocks, and heavy loads, these assemblies maintain tight steering feedback. Using this tie rod set helps keep the front end stable when plowing, hauling, or tackling aggressive trails.

Built For Performance

• Forged steel tie rod ends withstand high-impact steering forces
• Sealed ball joints with rubber dust boots block mud and water
• Adjustable center link allows precise toe alignment
• Corrosion-resistant plating protects against rust in wet conditions
• Pre-assembled with jam nuts for a quicker replacement
• OE-spec thread pitch and taper ensure a snug fit in the steering knuckle

Fits These Machines

• for Kawasaki KVF750 Brute Force 750 4X4i (2005-2016)

On-The-Job Use

• Mud and trail riding
• Farm and utility hauling
• Snow plowing with an ATV blade
• Rock crawling and technical terrain
• Recreational touring on rugged land

Specs At A Glance

Good To Know

Q: Do I need an alignment after replacing these tie rods? A: Yes, measure and set toe after installation to prevent uneven tire wear and ensure straight-line tracking.

Q: Are the tie rods pre-greased? A: The ball joints come factory-lubricated and the boots are sealed; they are maintenance-free under normal riding conditions.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.