2106CS Wiseco Piston Ring Set 53.50 mm for Wiseco
2106CS Wiseco Piston Ring Set 53.50 mm for Wiseco
Couldn't load pickup availability
Piston Ring Set for Wiseco 2106CS
This 53.50 mm piston ring set is designed to seal the combustion chamber and control oil on the cylinder wall for small engine and powersports rebuilds.
Overview
This piston ring set measures 53.50 mm and is built to restore compression in worn or freshly bored cylinders. It fits applications that use the 2106CS ring set and gives engine builders a dependable sealing solution for top-end service. Install it whenever pistons are replaced or cylinders are honed.
Built For Performance
- 53.50 mm bore size for a precise fit in matched cylinders
- Ring set configuration engineered for compression and oil control
- Hard-wearing ring faces resist friction and heat during operation
- Designed to seat quickly against freshly honed cylinder walls
- Suited to high-rpm small engine and powersports use
On-The-Job Use
- Top-end rebuilds on small engines and powersports machines
- Cylinder honing and piston replacement service
- Restoring compression on high-hour engines
- Routine refresh during seasonal maintenance
Specs At A Glance
| Part Number(s) | 2106CS |
| Ring Bore Size | 53.50 mm |
| Type | Piston ring set |
Good To Know
Q: How do I know this ring set fits my engine? A: Confirm the piston part number and bore size match 2106CS and 53.50 mm before ordering. Ring sets are bore-specific and will not seal correctly if the size is wrong.
Q: Should the cylinder be honed before installation? A: Yes, a light hone helps new rings seat properly against the cylinder wall. Check end gap and ring orientation during assembly.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
