211100009 Rubber Washer Cable Nut for Sea-Doo Explorer 720 1997 2002

Rubber Washer Cable Nut for Sea-Doo

This rubber washer cable nut, part number 211100009, is a replacement fastener that seals and secures cable connections on personal watercraft.

Overview

This rubber washer cable nut is a replacement hardware piece for Sea-Doo Explorer models, carrying OEM cross-reference 211100009. The rubber washer cable nut seals around cable pass-throughs to keep water out while holding the cable securely in place. It suits riders performing routine maintenance or restoring an older craft.

Built For Performance

• OEM cross-reference 211100009 for accurate matching
• Rubber washer design seals against water intrusion
• Secures cable routing at the hull pass-through
• Direct-fit replacement for worn or missing hardware
• Compatible with Sea-Doo Explorer 720 model years 1997 to 2002

Fits These Machines

• for Sea-Doo Explorer 720, 1997
• for Sea-Doo Explorer 720, 2002

On-The-Job Use

• Replacing a cracked or missing cable nut during hull maintenance
• Resealing cable entry points after cable service
• Restoring original hardware on older Explorer 720 watercraft
• Routine pre-season inspection and hardware refresh

Specs At A Glance

Good To Know

Q: Is this an original Sea-Doo part? A: This is a replacement rubber washer cable nut that cross-references part number 211100009. Confirm your model and serial number before ordering.

Q: Can I reuse the old washer? A: Reusing a worn or hardened rubber washer can allow water past the fitting. Replacing both the nut and washer together is the safer choice.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.