2136CS Ring Set 54.25mm for Wiseco 54.25mm Ring Set

Ring Set for Wiseco

This 54.25mm ring set is a replacement piston ring pack built to seal the combustion chamber and manage oil on rebuilt or refreshed engines, cross-referenced under part 2136CS.

Overview

The 2136CS ring set provides a precise 54.25mm bore fit for top-end work. This ring set pairs with the matching Wiseco piston to help restore compression and cut blow-by. It is aimed at engine builders and riders who need a correctly sized ring set for a 54.25mm bore.

Built For Performance

• 54.25mm bore sizing for a matched piston fit
• Ring set layout for compression and oil control
• Material chosen for heat and friction resistance at high rpm
• Supplied as a complete ring set for one piston
• Cross-referenced as part 2136CS

On-The-Job Use

• Top-end rebuilds on two-stroke and four-stroke engines
• Piston replacement jobs requiring fresh rings
• Performance engine assembly and refresh
• Servicing top ends with worn rings or low compression

Specs At A Glance

Good To Know

Q: How do I confirm this ring set is the right one? A: Check both the 54.25mm bore size and the 2136CS part number against your piston specification. The ring set must match the bore to seal correctly.

Q: Should ring end gaps be adjusted? A: Yes, end gaps should be measured and set during assembly per your engine builder's spec. Never assume a ring set is drop-in without checking the gap.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.