2175CD Ring Set 55.25mm for Wiseco

Ring Set for Wiseco - 2175CD - 55.25mm

This 55.25mm ring set is a replacement piston ring assembly designed to restore compression and oil control in a compatible 55.25mm bore engine top end, and it cross-references Wiseco part 2175CD.

Overview

This Wiseco 2175CD ring set is a 55.25mm piston ring assembly built to seal the combustion chamber against the cylinder wall and control oil on the piston skirt. It is made for riders and engine builders refreshing a top end on a compatible 55.25mm bore application. The 2175CD ring set works as a direct replacement when the original rings wear, lose tension, or are damaged during a rebuild.

Built For Performance

• 55.25mm bore sizing matched to a compatible piston
• Multi-ring set covering compression and oil control positions
• Cross-references Wiseco part number 2175CD
• Construction intended for high-heat four-stroke top end service
• Designed to restore piston-to-cylinder sealing after rebuild

Fits These Machines

• For applications using a 55.25mm bore piston that accepts Wiseco 2175CD rings

On-The-Job Use

• Top end rebuilds after ring wear or cylinder scoring
• Rebuilds where bore size has been confirmed at 55.25mm
• Piston replacement service on compatible engines
• Routine refresh during a full engine teardown

Specs At A Glance

Good To Know

Q: How do I confirm this ring set fits my piston? A: Match the 55.25mm bore size and the Wiseco 2175CD part number against your piston or rebuild spec before ordering. Ring thickness and groove dimensions must also match the piston being used.

Q: Can I install new rings on a worn cylinder? A: New rings seal best in a cylinder that has been measured, honed, or replated to the correct bore size and taper. Installing them in a worn bore can lead to poor compression and oil consumption.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.