Skip to product information
1 of 2

219459A Comet 20 Series Driven Unit 5/8" Bore 6" Diameter

219459A Comet 20 Series Driven Unit 5/8" Bore 6" Diameter

Regular price $208.99
Regular price Sale price $208.99
Sale Sold out
Quantity

20 Series Driven Unit for Comet

The 20 Series Driven Unit for Comet, part number 219459A, is a torque converter driven clutch assembly with a 5/8 inch bore and 6 inch diameter that delivers smooth automatic shifting on small engine and light utility vehicles.

Overview

This 20 Series Driven Unit for Comet replaces a worn or seized secondary clutch on belt driven torque converter systems. The 5/8 inch bore and 6 inch diameter sizing match compact engine setups, keeping belt engagement consistent through the full speed range. It suits builders, riders, and repair shops working on go karts, mini bikes, and similar small vehicles running a Comet 20 Series drive system.

Built For Performance

  • 5/8 inch bore fits matching jackshaft and driven shaft diameters
  • 6 inch diameter sheave maintains proper belt wrap and ratio range
  • Spring loaded cam design responds to load changes for smooth downshifting
  • Symmetrical sheave faces keep the belt running centered under torque
  • Part number 219459A stamped for the 20 Series driven position
  • Direct replacement for a failed driven unit on 20 Series systems

Fits These Machines

  • for Comet 20 Series torque converter drive systems
  • for go karts running a 20 Series secondary clutch assembly
  • for mini bikes and light utility vehicles with a 5/8 inch driven shaft

On-The-Job Use

  • Restoring belt engagement on go kart and mini bike builds
  • Replacing a seized or scored driven clutch during routine service
  • Servicing small engine drivetrains on yard and recreation vehicles
  • Keeping belt driven torque converters shifting predictably under load

Specs At A Glance

Part Number(s) 219459A
Series 20 Series, driven position
Bore 5/8 inch
Diameter 6 inch

Good To Know

Q: How do I know this driven unit fits my vehicle? A: It is built for 20 Series systems with a 5/8 inch driven shaft, so measure your shaft and confirm your drive clutch matches the 20 Series before ordering.

Q: Should the drive and driven clutches be replaced together? A: Inspect both units for worn sheaves and worn buttons, and replace the pair if either shows scoring, since mismatched wear causes belt slipping.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.

Get it between -

View full details