219464A 30 Series Driven Unit 3/4" Bore 7" Diameter for Comet
219464A 30 Series Driven Unit 3/4" Bore 7" Diameter for Comet
Couldn't load pickup availability
30 Series Driven Unit for Comet
This 30 Series driven unit is a torque converter clutch assembly that transfers power from the drive clutch to the output shaft on small engine drivetrains, listed under part numbers 219464A.
Overview
This 30 Series driven unit is a torque converter clutch that manages belt tension and gear ratio changes on small engine drivetrains. The driven unit pairs with a matching drive clutch to keep the belt running at the correct tension through acceleration and load changes. It suits riders, mini bikes, and light utility builds using the 30 Series system.
Built For Performance
- 7 inch diameter driven sheave for the 30 Series belt line
- 3/4 inch bore sized for the matching output jackshaft
- Spring loaded cam assembly that opens and closes the sheave under load
- Cast sheave halves machined for consistent belt contact
- Direct replacement for Comet part number 219464A
On-The-Job Use
- Mini bikes and go karts running 30 Series torque converters
- Light utility carts and yard haulers with small gas engines
- Rebuilds where a worn driven unit causes belt slip or slip chatter
- Custom builds needing a 7 inch driven sheave with a 3/4 inch bore
Specs At A Glance
| Part Number(s) | 219464A |
| Series | 30 Series |
| Component | Driven unit |
| Bore | 3/4 inch |
| Diameter | 7 inch |
Good To Know
Q: Does this unit come with the belt? A: No, the belt is not included, and the correct 30 Series belt should be matched to your center distance and pulley setup.
Q: Can I run this with any drive clutch? A: It is built to pair with a 30 Series drive clutch, and mixing series can cause belt misalignment and premature wear.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
