Skip to product information
1 of 1

2362CS Wiseco Piston Ring Set 60.00 mm for Wiseco

2362CS Wiseco Piston Ring Set 60.00 mm for Wiseco

Regular price $50.59
Regular price Sale price $50.59
Sale Sold out
Quantity

Piston Ring Set for Wiseco

This 60.00 mm piston ring set is a replacement ring assembly that seals the combustion chamber and controls oil on compatible pistons, and it carries the 2362CS reference number.

Overview

The 2362CS piston ring set is a 60.00 mm ring package built to seat against the cylinder wall and maintain compression in small-bore engines. This piston ring set suits rebuilders and riders refreshing a top end where the piston is still within spec and only the rings need replacing. Each set is sized at 60.00 mm so the piston ring set matches the bore it was cut for.

Built For Performance

  • 60.00 mm nominal bore sizing for a matched fit
  • Ring set configuration covering compression and oil control positions
  • Steel ring construction built to hold tension under heat cycling
  • Precision-ground faces for consistent wall contact
  • Identified by the 2362CS part reference for easy lookup

On-The-Job Use

  • Top-end rebuilds where the cylinder has been measured and honed
  • Restoring compression on a tired small-bore engine
  • Routine ring replacement during piston service
  • Shop work on engines that use 60.00 mm pistons

Specs At A Glance

Part Number(s) 2362CS
Bore Size 60.00 mm
Type Piston ring set

Good To Know

Q: How do I know this ring set fits my piston? A: Check that your piston and cylinder are both sized at 60.00 mm and that the piston calls for the 2362CS ring pack before ordering.

Q: Can I install rings without checking the bore? A: No, the cylinder should be measured for taper and out-of-round and honed as needed, since worn bores will not let new rings seat properly.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.

Get it between -

View full details