Skip to product information
1 of 1

2410369 Knock Sensor for Polaris Switchback 600 2004-2017 Detonation

2410369 Knock Sensor for Polaris Switchback 600 2004-2017 Detonation

Regular price $136.39
Regular price Sale price $136.39
Sale Sold out
Quantity

Knock/Detonation Sensor for Polaris Switchback 600

This knock/detonation sensor replaces OEM part 2410369 on Polaris Switchback 600 snowmobiles built from 2004 through 2017, detecting abnormal combustion so the ECU can adjust ignition timing and protect the engine.

Overview

This knock/detonation sensor for Polaris Switchback 600 is a direct-fit replacement that monitors engine block vibration and reports detonation events to the ignition system. Cross-referencing OEM number 2410369, it helps restore proper timing control on 2004-2017 Switchback 600 models. Choose this knock/detonation sensor for Polaris to keep your engine running reliably on every ride.

Built For Performance

  • Cross-references OEM part number 2410369 for easy verification
  • Piezo-electric element calibrated for two-stroke detonation frequencies
  • Sealed connector and housing built for cold and moisture exposure
  • Direct-fit mounting at the factory location on the Switchback 600 engine
  • Stable signal output across the full operating temperature range
  • Bolt-on installation with standard hand tools

Fits These Machines

  • for Polaris Switchback 600 (2004-2017)

On-The-Job Use

  • Trail riding where engine load varies constantly and timing needs quick adjustment
  • Long lake and fire road pulls that stress the top end
  • Mountain riding at altitude where fuel quality and load can trigger detonation
  • Routine top-end rebuilds and electrical troubleshooting on Switchback 600 sleds

Specs At A Glance

Part Number(s) 2410369
Part Type Knock/Detonation Sensor
Position Engine block, factory location
Compatible Years 2004-2017
Compatible Model Switchback 600

Good To Know

Q: What symptoms point to a bad knock sensor on a Switchback 600? A: Loss of power, poor fuel economy, rough idle, and stored fault codes are typical. Replacing the sensor with this 2410369 cross-reference unit usually clears those symptoms.

Q: Can I install this sensor without special tools? A: Yes, it mounts with a single bolt at the factory location and uses a plug-in connector. Use a torque wrench to hit the specified value so the sensor reads correctly.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.

Get it between -

View full details