244 Std Piston for Polaris Gemini 250 1979-1983
244 Std Piston for Polaris Gemini 250 1979-1983
Couldn't load pickup availability
Std Piston for Polaris Gemini 250
This standard-bore piston is a direct replacement engine component for the Polaris Gemini 250, sized to original specifications to restore compression and smooth piston travel in the cylinder.
Overview
This Std Piston is a replacement engine component built for the Polaris Gemini 250. It is designed to fit the standard bore cylinder and restore proper compression and piston movement. The Std Piston for Polaris Gemini 250 is intended for rebuilds and top-end service on machines that have not been overbored.
Built For Performance
- Standard bore sizing to match an unmodified cylinder
- Constructed for reliable compression in a two-stroke top end
- Machined skirt and ring grooves for consistent ring seating
- Balanced for smooth operation across the RPM range
- Sold as a new piston, not a remanufactured unit
Fits These Machines
- for Polaris Gemini 250, 1979-1983
On-The-Job Use
- Top-end rebuilds on Gemini 250 models
- Restoring compression after piston or ring wear
- Routine engine maintenance on older Polaris two-strokes
- Replacing a scored or damaged standard-bore piston
Specs At A Glance
| Part Number(s) | 244 |
| Bore Size | Standard |
| Condition | New |
| Machine | for Polaris Gemini 250 |
Good To Know
Q: Does this piston require a specific ring set? A: Yes, matching standard-bore rings should be used during installation. Confirm the ring part number against your cylinder before assembly.
Q: Can this be used in an overbored cylinder? A: No, this is a standard-bore piston and is not intended for oversized cylinders. Measure bore clearance before ordering to confirm fit.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
