2539CS Wiseco Piston Ring Set 64.50 mm for Wiseco 64.50mm Ring
2539CS Wiseco Piston Ring Set 64.50 mm for Wiseco 64.50mm Ring
Couldn't load pickup availability
Piston Ring Set for Wiseco
This 64.50 mm piston ring set is a replacement ring set that seals the combustion chamber and manages oil control on the cylinder wall in small engine and powersport builds.
Overview
This 64.50 mm piston ring set delivers the sealing and oil control a rebuilt top end requires to run at full compression. Made as a replacement ring set for Wiseco pistons, it presses against the cylinder wall to hold compression on a fresh or refinished bore. It is intended for engine builders and riders servicing a top end where the piston remains serviceable but the rings need replacing.
Built For Performance
- 64.50 mm ring diameter sized for a matching overbore piston
- Ring set configuration for one piston assembly
- Steel construction built to maintain tension under combustion heat
- Precision ground face for steady wall contact and sealing
- Produced as a replacement component for Wiseco piston assemblies
Specs At A Glance
| Ring Diameter | 64.50 mm |
| Part Number(s) | 2539CS |
| Type | Piston ring set |
Good To Know
Q: How can I verify this ring set fits my piston? A: Match the 64.50 mm ring diameter and the 2539CS number to the piston in your engine, since ring sets are made for a specific bore size. A: Check the part number on your piston documentation before ordering.
Q: Is it acceptable to fit new rings on a used piston? A: Yes, provided the piston and bore measure within tolerance, new rings alone can bring compression back. A: Verify ring end gap and cylinder taper during assembly.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
