2648CD Ring Set 67.25mm for Wiseco Piston Rings

Ring Set for Wiseco

This Wiseco 2648CD ring set at 67.25mm is a piston ring replacement sized to that bore, made to seal against the cylinder wall and control compression and oil on the piston skirt during a top end rebuild.

Overview

This ring set for Wiseco is a 67.25mm piston ring replacement for rebuilt or refreshed top ends. Each ring set for Wiseco is sized to the listed bore so you can match it to the piston it was built for. It suits riders, builders, and mechanics handling a top end service where the piston already matches this ring set.

Built For Performance

• Ring set built to Wiseco 2648CD specification
• 67.25mm bore sizing for a matched piston fit
• Designed to seal against the cylinder wall for compression control
• Rings formed for consistent tension around the piston circumference
• Sold as a matched ring set for the listed piston application

On-The-Job Use

• Top end rebuilds on small engines and power equipment
• Piston ring replacement during a cylinder service
• Refresh work before reassembling a worn top end
• Shop and garage repair jobs on matched piston assemblies

Specs At A Glance

Good To Know

Q: Is this an original Wiseco ring set? A: This listing is a ring set for Wiseco referencing part number 2648CD and is not presented as an original brand item. Confirm the part number and 67.25mm bore match your piston before ordering.

Q: How do I confirm the 67.25mm size is right for my engine? A: Check the bore measurement and the 2648CD part number against the piston or ring set you are replacing. Fit can depend on bore size and piston revision, so verify before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.