267000054 Impeller Shaft for Sea-Doo RXT 1503 2005-2006

Impeller Shaft for Sea-Doo

This impeller shaft (OEM cross-reference 267000054) is the driveline component that transfers power from the engine to the jet pump impeller for Sea-Doo watercraft.

Overview

This impeller shaft is a replacement driveline component that connects the engine output to the jet pump on Sea-Doo personal watercraft. Built to the 267000054 specification, the impeller shaft keeps the pump spinning so thrust stays consistent under acceleration. It suits riders repairing or refreshing the jet drive on their Sea-Doo machine.

Built For Performance

• Manufactured to meet 267000054 dimensional and fitment specifications
• Machined splines for positive engagement with the impeller
• Heat-treated steel construction for torsional strength under load
• Corrosion-resistant surface finish suited to marine environments
• Balanced shaft profile to reduce vibration at speed

Fits These Machines

• for Sea-Doo RXT 1503 (2005-2006)

On-The-Job Use

• Jet pump driveline repair on Sea-Doo RXT 1503 watercraft
• Routine jet drive service and impeller replacement jobs
• Restoring thrust after wear or spline damage on a used pump

Specs At A Glance

Good To Know

Q: Is this an original Sea-Doo part? A: No, this is an aftermarket impeller shaft built to cross-reference 267000054, not an original factory component. Q: What else should I check when replacing an impeller shaft? A: Inspect the impeller splines, bearings, and seals for wear at the same time, since damage in those areas often causes shaft problems.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.