267000054 Impeller Shaft for Sea-Doo Utopia SE 430 1503 2008

Impeller Shaft for Sea-Doo

This impeller shaft for Sea-Doo is a replacement driveline component that transfers power from the engine to the jet pump impeller, and it cross-references OEM part number 267000054.

Overview

This impeller shaft for Sea-Doo is built to serve as a direct-fit replacement for a worn or damaged shaft in the jet propulsion system. The impeller shaft for Sea-Doo connects the engine output to the pump, keeping thrust consistent on the water. It suits riders and mechanics maintaining a Sea-Doo Utopia SE 430 1503 from 2008.

Built For Performance

• Precision-machined splines for positive engagement with the impeller
• Constructed from corrosion-resistant marine-grade alloy
• Balanced design to reduce vibration at high RPM
• Treated surface for wear resistance in continuous wet use
• Built to OEM dimensional specifications for part 267000054

Fits These Machines

• for Sea-Doo Utopia SE 430 1503, 2008

On-The-Job Use

• Restoring jet pump drive on a Sea-Doo Utopia SE 430
• Routine driveline maintenance during pump service
• Replacing a bent or spline-worn shaft after ingesting debris
• Shop rebuilds and seasonal tune-ups

Specs At A Glance

Good To Know

Q: Is this an original Sea-Doo part? A: No, this is an aftermarket impeller shaft made to fit Sea-Doo applications and cross-references part number 267000054. Always verify your machine's serial number before ordering.

Q: Will I need any other parts during installation? A: Shaft replacement often calls for new seals, bearings, or wear rings depending on condition. Inspect the pump assembly and replace worn hardware at the same time.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.