267000388 Impeller Shaft for Sea-Doo Base Compact 100 1630 2022

Impeller Shaft for Sea-Doo

This impeller shaft for Sea-Doo personal watercraft transfers drive force from the engine to the jet pump, referencing OEM part number 267000388.

Overview

This impeller shaft for Sea-Doo is the driveline component that carries rotational power from the engine output to the jet pump impeller. Built as a direct-fit replacement, it keeps the pump spinning so thrust stays consistent on the water. It suits riders maintaining or rebuilding the jet drive on their Sea-Doo watercraft.

Built For Performance

• Direct replacement for OEM part number 267000388
• Machined shaft geometry for accurate spline and bearing fitment
• Heat-treated steel construction for torsional strength under load
• Balanced design to reduce vibration at high pump speeds
• Corrosion-resistant surface treatment for marine use

Fits These Machines

• for Sea-Doo Base Compact 100 1630, 2022

On-The-Job Use

• Jet pump rebuilds and driveline replacement
• Routine powertrain maintenance on personal watercraft
• Restoring thrust after impeller or wear ring service

Specs At A Glance

Good To Know

Q: Does this impeller shaft replace the original part directly? A: It is made to match OEM part number 267000388 for direct fitment. Always confirm your model and serial number before ordering.

Q: Should the shaft be installed with new bearings and seals? A: Replacing bearings and seals at the same time is good practice during a pump rebuild. This helps prevent premature wear on the new shaft.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.