267000388 Impeller Shaft for Sea-Doo Challenger SE 430 1503 2010-2011

Impeller Shaft for Sea-Doo

This impeller shaft for Sea-Doo is a replacement driveline component that connects the jet pump impeller to the engine output, referencing OEM part number 267000388.

Overview

This impeller shaft for Sea-Doo is built to transfer rotational power from the engine to the jet pump impeller in Challenger SE 430 watercraft. As a direct-fit replacement referencing part number 267000388, this impeller shaft keeps your jet propulsion system turning reliably season after season. It suits owners performing routine driveline maintenance or replacing a worn shaft.

Built For Performance

• Constructed from hardened marine-grade steel for torque loads
• Machined splines for positive engagement with the impeller
• Precision-ground bearing surfaces for smooth rotation
• Corrosion-resistant finish suited to constant water exposure
• Balanced to reduce vibration at high RPM
• Direct replacement referencing OEM part number 267000388

Fits These Machines

• for Sea-Doo Challenger SE 430 1503, 2010-2011

On-The-Job Use

• Routine jet pump driveline rebuilds
• Replacing a bent or scored impeller shaft
• Seasonal maintenance on Challenger SE 430 craft
• Restoring propulsion after driveline wear

Specs At A Glance

Good To Know

Q: Is this an original Sea-Doo part? A: No, this is an aftermarket impeller shaft that references OEM part number 267000388 for fitment. Always compare your existing part number before ordering.

Q: Do I need special tools to install it? A: Jet pump removal typically requires a spline tool and torque wrench. Follow your service manual for correct assembly and torque values.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.