267000388 Impeller Shaft for Sea-Doo Challenger SP 310 1503 2010-2011

Impeller Shaft for Sea-Doo Challenger SP 310 1503

This impeller shaft is a replacement driveline component for the Sea-Doo Challenger SP 310 1503, carrying OEM cross-reference 267000388, and it transfers engine torque through the jet pump to spin the impeller.

Overview

The impeller shaft for Sea-Doo Challenger SP 310 1503 is the connecting driveline part that carries power from the engine to the jet pump impeller. Built to the 267000388 reference, this shaft helps restore reliable thrust in 2010 to 2011 Challenger SP 310 1503 watercraft. It suits owners doing driveline repair or routine jet pump service.

Built For Performance

• Direct cross-reference to OEM part number 267000388
• Machined steel construction for torsional load handling
• Splined ends for positive engagement with the impeller and driveline
• Designed for the 1503 engine platform used in the Challenger SP 310
• Drop-in replacement footprint for straightforward jet pump service

Fits These Machines

• for Sea-Doo Challenger SP 310 1503, 2010-2011

On-The-Job Use

• Rebuilding a jet pump after impeller or wear ring damage
• Restoring driveline power transfer on a 2010 to 2011 Challenger SP 310 1503
• Routine driveline inspection and replacement during off-season service

Specs At A Glance

Good To Know

Q: Does this impeller shaft replace the factory part on the Challenger SP 310 1503? A: Yes, it cross-references OEM part number 267000388 and is intended for the 2010 to 2011 Challenger SP 310 1503 jet pump driveline.

Q: Should the shaft be replaced during jet pump service? A: If the shaft shows wear, corrosion, or spline damage, replacing it along with the impeller and wear ring helps keep driveline power transfer consistent.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.