267000388 Impeller Shaft for Sea-Doo GTX 155 STD 1503 2014

Impeller Shaft for Sea-Doo GTX 155 STD

This impeller shaft is a replacement driveline component that carries power from the engine to the jet pump impeller, and it cross-references OEM number 267000388.

Overview

This impeller shaft is made to fit Sea-Doo GTX 155 STD watercraft running the 1503 engine and keeps the engine-to-pump connection turning under load. The 267000388 impeller shaft restores the driveline on a 2014 GTX 155 STD so the jet pump can deliver thrust as intended. It gives owners a direct-fit replacement for a bent, worn, or corroded original.

Built For Performance

• Marine-grade metal construction resists corrosion in both salt and fresh water
• Splined ends machined for a tight fit at the engine and impeller hub
• Balanced profile to reduce vibration through the pump assembly
• Cross-references OEM number 267000388 for straightforward matching
• Rated for the load of the 1503 engine in the GTX 155 STD hull

Fits These Machines

• for Sea-Doo GTX 155 STD with 1503 engine, 2014

On-The-Job Use

• Driveline service when the original shaft shows runout or surface wear
• Jet pump rebuilds where the shaft is removed with the impeller
• Repairs after debris or bearing failure inside the pump housing
• Bringing a stored GTX 155 STD back into service

Specs At A Glance

Good To Know

Q: Will this shaft drop into my 2014 GTX 155 STD? A: It is listed for that model year and engine, so confirm your hull and engine match before ordering. Serial number differences can affect fit, so check your machine details.

Q: Should I replace bearings and seals at the same time? A: It is common to renew pump bearings and seals while the shaft is out of the housing. Inspect the old parts to decide what the job needs.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.