267000388 Impeller Shaft for Sea-Doo Speedster 1 x 155 1503 2012

Impeller Shaft for Sea-Doo

This impeller shaft for Sea-Doo watercraft transfers drive torque from the engine to the jet pump impeller, and it carries OEM cross-reference 267000388 for straightforward replacement.

Overview

This impeller shaft is a direct replacement component for the jet propulsion system on select Sea-Doo models. The shaft connects the engine output to the impeller inside the pump, keeping thrust steady under load. It suits riders and mechanics repairing a Speedster or similar 1503-powered craft.

Built For Performance

• Machined from hardened marine-grade steel for corrosion resistance in wet environments
• Splined ends engineered to mate with the impeller and engine coupler
• Precision-balanced to reduce vibration at high RPM
• Heat-treated surface for wear resistance under continuous load
• Direct replacement for OEM part 267000388

Fits These Machines

• for Sea-Doo Speedster with 1503 engine
• for Sea-Doo models running the 155 and 1503 powerplant

On-The-Job Use

• Jet pump rebuilds and impeller replacements
• Driveline repairs after bearing or seal failure
• Routine maintenance on 1503-equipped watercraft
• Seasonal service before launching

Specs At A Glance

Good To Know

Q: Does this shaft fit every Sea-Doo with a 1503 engine? A: Fitment depends on the specific model and model year, so verify your hull and engine combination before ordering. Check your serial number against the listed part number.

Q: Is this an original Sea-Doo part? A: This is an aftermarket replacement component built to match OEM part 267000388. It is not manufactured by Sea-Doo.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.