267000428 Jet Pump Nose Cone for Sea-Doo Speedster 310 1503 2008

Jet Pump Nose Cone for Sea-Doo Speedster 310 1503

This jet pump nose cone is a replacement component for the 2008 Sea-Doo Speedster 310 1503, directing water flow into the jet pump assembly and helping protect the impeller from debris drawn into the intake.

Overview

This jet pump nose cone is a replacement component built for the 2008 Sea-Doo Speedster 310 1503, sitting at the front of the pump assembly to guide water into the impeller and shield it from debris. The nose cone plays a key role in maintaining smooth flow through the jet pump, protecting the impeller and wear ring from rocks, sand, and other material that can cause cavitation and damage. This jet pump nose cone is intended for riders and mechanics servicing the 1503 engine platform who need a reliable replacement for a worn or missing original.

Built For Performance

• Direct replacement fitment for the jet pump assembly on the 2008 Sea-Doo Speedster 310 1503
• Streamlined profile helps guide water into the impeller with minimal turbulence
• Shields the impeller and wear ring from rocks, sand, and debris pulled through the intake
• Helps reduce cavitation for more consistent thrust and acceleration
• Reference part number 267000428 for cross-fitment checks
• Constructed for marine use in fresh and salt water environments

Fits These Machines

• for Sea-Doo Speedster 310 1503 (2008)

On-The-Job Use

• Replacing a cracked or worn nose cone during jet pump service
• Restoring smooth water flow to the impeller after debris damage
• Routine maintenance on the 1503 jet pump assembly
• Keeping recreational riding performance consistent on the water

Specs At A Glance

Good To Know

Q: How do I know if my jet pump nose cone needs replacing? A: Inspect the nose cone for cracks, deep gouges, or missing sections after any impact with debris or during routine pump service. A damaged nose cone can let debris reach the impeller and cause cavitation or loss of thrust.

Q: Does the nose cone require any special tools to install? A: Installation generally follows the jet pump disassembly and reassembly procedure for the 1503 platform, so basic hand tools and a torque wrench for the pump housing fasteners are typically needed. Refer to your service manual for the correct sequence and torque values.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.