267000469 Jet Pump Rear Plug for Sea-Doo Speedster Wake 310 1503 2008

Jet Pump Rear Plug for Sea-Doo

This jet pump rear plug is a rear plug for the jet pump on Sea-Doo Speedster Wake 310 and 1503 applications, sealing the pump housing to keep water where it belongs.

Overview

This jet pump rear plug is designed for Sea-Doo Speedster Wake 310 and 1503 jet pump applications, closing off the rear of the pump housing. The rear plug helps keep the pump sealed so water moves through the impeller properly and does not leak past the housing. It suits owners and shops servicing 2008 Sea-Doo watercraft.

Built For Performance

• Seals the rear of the jet pump housing
• Helps maintain correct pump pressure and flow
• Direct replacement for the original rear plug
• Simple install during pump service or rebuild
• Fits 1503 jet pump applications

Fits These Machines

• for Sea-Doo Speedster Wake 310
• for Sea-Doo 1503 engine applications
• for Sea-Doo 2008 models

On-The-Job Use

• Jet pump removal and rebuild service
• Replacing a lost, cracked, or leaking rear plug
• Routine pump maintenance on Speedster Wake 310 craft
• Shop repair work on 2008 Sea-Doo models

Specs At A Glance

Good To Know

Q: What does the rear plug do on a jet pump? A: It seals the back of the pump housing so water flows through the impeller instead of escaping. A damaged plug can cause cavitation and loss of thrust.

Q: Is any sealant needed when installing it? A: Many installations use a sealant or O-ring as specified in your service manual. Always follow the manufacturer procedure for a proper seal.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.