267001187 Jet Pump Wear Ring for Sea-Doo Spark DT 900 2014 Fits

Jet Pump Wear Ring for Sea-Doo Spark DT 900

This jet pump wear ring, reference 267001187, is a replacement wear ring that maintains the tight clearance between the impeller and pump housing on Sea-Doo Spark DT 900 watercraft for consistent thrust and reduced cavitation.

Overview

This jet pump wear ring is a direct replacement component for the Sea-Doo Spark DT 900 jet pump assembly. The wear ring sits around the impeller to keep the clearance tight, protecting thrust output as the ring takes the gradual wear instead of the pump housing. It is intended for owners servicing or rebuilding the jet pump on their Spark DT 900.

Built For Performance

• Wear ring design protects the pump housing and impeller from abrasive damage
• Maintains proper impeller clearance for strong, consistent thrust
• Helps reduce cavitation and loss of acceleration caused by worn clearances
• Direct fit replacement for 267001187
• Suited to the Sea-Doo Spark DT 900 jet pump assembly

Fits These Machines

• for Sea-Doo Spark DT 900

On-The-Job Use

• Jet pump rebuilds and seasonal servicing
• Restoring lost acceleration and hole shot on the water
• Replacing a worn ring before it damages the impeller
• Routine maintenance on Sea-Doo Spark DT 900 watercraft

Specs At A Glance

Good To Know

Q: How do I know the wear ring needs replacing? A: Common signs include cavitation, weak hole shot, and vibration that grows worse over time. Inspecting the ring clearance during pump service confirms whether replacement is due.

Q: Is this an original Sea-Doo part? A: This is an aftermarket replacement wear ring made to fit the Sea-Doo Spark DT 900 described and cross-referenced to 267001187. It is not an original Sea-Doo product.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.