2677LT Ring Set 68.00mm for Wiseco Piston Rings

Ring Set for Wiseco

The Wiseco 2677LT ring set measures 68.00mm and provides the sealing rings needed to restore compression in a rebuilt piston assembly.

Overview

This 68.00mm ring set is made to pair with a matching Wiseco piston during a top end rebuild. The ring set for Wiseco 2677LT covers the compression and oil control rings needed to seal the combustion chamber. It suits riders and mechanics rebuilding a worn or damaged top end.

Built For Performance

• 68.00mm bore sizing for a matched piston fit
• Ring set configuration covering compression and oil control
• Reference number 2677LT for straightforward identification
• Built to OEM-style tolerances for consistent sealing
• Suited to rebuild and refresh work on a worn top end

On-The-Job Use

• Top end rebuilds after a piston or ring failure
• Routine refresh of a high hour engine
• Shop work where bore size must match the piston exactly

Specs At A Glance

Good To Know

Q: Should the ring set be matched to the piston? A: Yes, ring sets are sized to a specific piston and bore, so confirm the 68.00mm figure matches your piston before ordering.

Q: Can rings be installed without checking end gap? A: No, ring end gap should always be checked and set during assembly to avoid poor sealing or damage.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.