2697CS Ring Set for Wiseco 68.50mm Piston Rings

Ring Set for Wiseco

This Wiseco 2697CS ring set at 68.50mm is a piston ring kit that seals the combustion chamber and manages oil on the cylinder wall.

Overview

The Wiseco 2697CS ring set provides a fresh seal at 68.50mm bore size for your top end build. This ring set works alongside the matching Wiseco piston to restore compression and oil control. It is aimed at riders and builders refreshing a worn engine.

Built For Performance

• 68.50mm bore sizing for a precise fit in the matching cylinder
• Multi-ring design covering compression and oil control duties
• Built to withstand high-rpm engine operation
• Sold as a complete set for one piston
• Matches the corresponding Wiseco piston part number

On-The-Job Use

• Top end rebuilds after piston replacement
• Restoring compression on a smoking or tired engine
• Routine refresh during full engine service
• Performance engine assembly where ring seal matters

Specs At A Glance

Good To Know

Q: Should ring end gap be checked before assembly? A: Yes, end gap should be measured and set to your engine specification before the cylinder goes back on. This helps prevent binding and poor sealing.

Q: Will this set fit my existing piston? A: These rings are sized for a 68.50mm bore and are meant to match the corresponding piston. Verify piston and bore size before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.