2698XA Ring Set for Wiseco 68.50mm Piston Rings

Ring Set for Wiseco

This Wiseco 2698XA ring set at 68.50mm is a piston ring kit that seals the combustion chamber and controls oil on the cylinder wall.

Overview

The Wiseco 2698XA ring set gives your top end a fresh seal at 68.50mm bore size. This ring set works with the matching Wiseco piston to restore compression and oil control on rebuilt engines. It suits riders and mechanics refreshing a worn top end.

Built For Performance

• 68.50mm bore sizing for a precise fit in the matching cylinder
• Multi-ring design covering compression and oil control duties
• Constructed for high-rpm four-stroke and two-stroke top ends
• Sold as a complete set for one piston
• Pairs with the corresponding Wiseco piston part number

On-The-Job Use

• Top end rebuilds after a piston replacement
• Restoring compression on a worn or smoking engine
• Routine refresh during a full engine service
• Race engine assembly where ring seal matters

Specs At A Glance

Good To Know

Q: Do I need to gap these rings before installation? A: Yes, ring end gap should always be checked and set to the specification for your engine before assembly. Proper gapping protects against binding and poor sealing.

Q: Can I reuse my old piston with this ring set? A: These rings are sized for a 68.50mm bore and are intended to match the corresponding piston. Confirm your piston and bore size before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.