270-0002-51 Throttle Position Sensor for Ski-Doo MXZ 600 HO SDI All 2004-2008

Throttle Position Sensor for Ski-Doo

The Throttle Position Sensor cross-references OEM part 270-0002-51 and relays throttle plate angle to the engine management system on the Ski-Doo MXZ 600 HO SDI.

Overview

This Throttle Position Sensor for Ski-Doo delivers the throttle angle signal the SDI engine management system relies on for correct fuel delivery and ignition timing. Built as a direct replacement for OEM 270-0002-51, this throttle position sensor restores the crisp throttle response riders expect from the MXZ 600 HO SDI. It suits riders performing routine sensor replacement or chasing driveability issues on 2004 to 2008 machines.

Built For Performance

• Direct replacement for OEM part number 270-0002-51
• Provides accurate throttle plate angle signal to the SDI control module
• Supports correct fuel delivery and ignition timing across the rev range
• Sealed housing resists snow, moisture, and vibration
• Plug-in connector matches the factory harness

Fits These Machines

• for Ski-Doo MXZ 600 HO SDI, 2004-2008

On-The-Job Use

• Restoring correct throttle response on SDI-equipped trail sleds
• Diagnosing and resolving driveability complaints tied to throttle angle signal faults
• Routine replacement during engine sensor service
• Refreshing a high-mileage sled before the riding season

Specs At A Glance

Good To Know

Q: Is this an original Ski-Doo part? A: This is an aftermarket throttle position sensor engineered to replace OEM 270-0002-51, not an original Ski-Doo part.

Q: Will this fit my specific MXZ 600 HO SDI? A: It is listed for 2004-2008 MXZ 600 HO SDI models, but serial number and build variation can affect fit, so confirm compatibility before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.