270-0002-51 Throttle Position Sensor for Ski-Doo MXZ X 800 E-Tec 2010-2017
270-0002-51 Throttle Position Sensor for Ski-Doo MXZ X 800 E-Tec 2010-2017
Couldn't load pickup availability
Throttle Position Sensor for Ski-Doo
This throttle position sensor, part number 270-0002-51, monitors throttle valve angle and relays that signal to the engine control module for accurate fuel delivery and ignition timing.
Overview
This throttle position sensor is a direct-fit replacement for the factory unit on select Ski-Doo MXZ X 800 E-Tec snowmobiles. The sensor reports throttle plate position to the ECM so the engine manages fuel and spark correctly. It suits riders replacing a failed or erratic sensor on a 2010-2017 MXZ X 800 E-Tec.
Built For Performance
- Direct-fit replacement for the OEM throttle position sensor
- Part number 270-0002-51 for straightforward identification
- Sealed housing resists snow, moisture, and vibration
- Accurate resistance output across the full throttle range
- Plug-in connector matches the factory harness
Fits These Machines
- for Ski-Doo MXZ X 800 E-Tec, 2010-2017
On-The-Job Use
- Restoring correct throttle response on trail rides
- Replacing a sensor that causes rough idle or hesitation
- Routine service on high-mileage E-Tec engines
Specs At A Glance
| Part Number(s) | 270-0002-51 |
| Component | Throttle Position Sensor |
| Compatibility | for Ski-Doo MXZ X 800 E-Tec, 2010-2017 |
Good To Know
Q: How do I know my throttle position sensor needs replacing? A: Common signs include rough idle, hesitation, or a check engine light. A scan tool reading that shows erratic throttle voltage confirms diagnosis.
Q: Does this sensor require calibration after installation? A: Most E-Tec systems relearn throttle position automatically after install. Verify with a scan tool to confirm the reading falls within spec.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
