270-0002-51 Throttle Position Sensor for Ski-Doo Skandic WT 600 E-Tec 2011-2018
270-0002-51 Throttle Position Sensor for Ski-Doo Skandic WT 600 E-Tec 2011-2018
Couldn't load pickup availability
Throttle Position Sensor for Ski-Doo Skandic WT 600 E-Tec
This throttle position sensor, OEM cross-reference 270-0002-51, is an aftermarket replacement component that reports throttle valve position to the engine management system on 2011-2018 Ski-Doo Skandic WT 600 E-Tec models.
Overview
This throttle position sensor for Ski-Doo Skandic WT 600 E-Tec snowmobiles delivers the throttle input signal the ECU needs for correct fuel delivery and ignition timing. A worn throttle position sensor can cause rough running, hesitation, or fault codes, so replacing it keeps the engine responding as it should. It is a practical service part for owners of 2011-2018 Skandic WT 600 E-Tec machines.
Built For Performance
- Direct-fit replacement for OEM part number 270-0002-51
- Delivers accurate throttle position data to the engine management system
- Sealed housing resists snow, moisture, and engine bay heat
- Plug-in electrical connection for straightforward installation
- Helps restore steady idle and clear throttle response
Fits These Machines
- for Ski-Doo Skandic WT 600 E-Tec 2011
- for Ski-Doo Skandic WT 600 E-Tec 2012
- for Ski-Doo Skandic WT 600 E-Tec 2013
- for Ski-Doo Skandic WT 600 E-Tec 2014
- for Ski-Doo Skandic WT 600 E-Tec 2015
- for Ski-Doo Skandic WT 600 E-Tec 2016
- for Ski-Doo Skandic WT 600 E-Tec 2017
- for Ski-Doo Skandic WT 600 E-Tec 2018
On-The-Job Use
- Utility and work riding on Skandic WT 600 E-Tec models
- Routine maintenance of the throttle body and sensor circuit
- Diagnosing and clearing throttle-related fault codes
- Restoring smooth throttle engagement after a sensor failure
- Pre-season service and inspection
Specs At A Glance
| Part Number(s) | 270-0002-51 |
| Type | Throttle Position Sensor |
| Fitment | for Ski-Doo Skandic WT 600 E-Tec 2011-2018 |
Good To Know
Q: Is this an original Ski-Doo part? A: No, this is an aftermarket throttle position sensor that cross-references OEM number 270-0002-51. It is designed to fit the listed Skandic WT 600 E-Tec models.
Q: Will I need to reset anything after installing it? A: On many machines the ECU relearns the closed throttle position after a few start cycles. Confirm the correct procedure in your service manual for your exact model year.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
