271000290 Jet Pump Wear Ring for Sea-Doo GTI 720 1996-2000

Jet Pump Wear Ring for Sea-Doo

This jet pump wear ring for Sea-Doo watercraft replaces OEM part 271000290 to restore proper clearance between the impeller and pump housing.

Overview

This jet pump wear ring for Sea-Doo is a replacement component that maintains the tight tolerance between the impeller and the pump housing wall. A worn wear ring allows water to bypass the impeller, which reduces thrust and acceleration. This wear ring for Sea-Doo is intended for riders performing routine pump maintenance on GTI 720 models from 1996 through 2000.

Built For Performance

• Direct replacement for OEM part number 271000290
• Maintains impeller-to-housing clearance for consistent thrust
• Restores lost acceleration caused by a worn or grooved ring
• Designed to seat into the jet pump housing without modification
• Suits routine pump rebuild and impeller service

Fits These Machines

• for Sea-Doo GTI 720, 1996
• for Sea-Doo GTI 720, 1997
• for Sea-Doo GTI 720, 1998
• for Sea-Doo GTI 720, 1999
• for Sea-Doo GTI 720, 2000

On-The-Job Use

• Pump rebuilds after impeller damage or ingestion of debris
• Routine wear ring replacement during off-season service
• Restoring holeshot and top speed on high-hours GTI 720 craft
• Servicing pumps that show visible scoring or grooves

Specs At A Glance

Good To Know

Q: How do I know the wear ring needs replacing? A: Check the clearance between the impeller blade tips and the ring surface, along with any visible grooves or gouges in the ring. Excessive clearance or scoring reduces pump efficiency and calls for replacement.

Q: Does the wear ring come with installation hardware? A: This listing covers the wear ring itself as referenced by OEM number 271000290. Reuse or source seals and fasteners separately based on the condition of your pump assembly.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.